Refer to the following directions for installing a standard toilet seat that does not use Quick- Attach hardware. If your toilet seat is a Q2 or Q3 seat, refer to the additional resources section.
- Begin by snapping open the hinge covers (Fig. 1).
- Align the holes underneath the covers with the holes in the toilet bowl (Fig. 2). If your seat comes with a metal washer and rubber washer, the rubber washer goes in-between the hinge and china.
- Fit the bolts through the hinges from the top (Fig. 3).
- Thread the plastic nuts on the bolts from below. It is best to tighten the bolts from the top, like a screw, holding on to the bolts if necessary. Keep the seat straight and centered as you tighten the bolts (Fig. 4).
- Once the seat is secure, snap the hinge covers closed again and your toilet seat installation is complete.
(Fig. 1) |
(Fig. 2) |
(Fig. 3) |
(Fig. 4) |