Follow the steps below to install a valve body with hoses into a pull-out spray kitchen faucet.
- Make sure to shut off water at the supplies before you start this replacement process.
- Remove the handle by loosening the set screw located on the short side of the handle (Fig. 1).
- Remove the Phillips screw holding the adapter in place. Then pull off the adapter (Fig. 2).
- Pop off the bonnet, or decorative covering, by pulling it off.
- Turn off the valve mounting nut by turning it counterclockwise and pull out the valve to remove it (Fig. 3) and (Fig. 4).
- Remove the gooseneck spout by pulling up or using a screwdriver to gently pry and pull the spout up (Fig. 5) and (Fig. 6).
- Disconnect the pull-out sprayhead hose below the counter by pushing the grey tab on the white connector (Fig. 7).
- Pull the hose out through the top of the faucet.
- Remove the hose guide that is seated in the underside of the faucet boy by using a set of pliers and grabbing the guide and pulling downward (Fig. 8) and (Fig. 9).
- Remove the valve body. Using a pair of needle nose pliers, grab the bottom and upper right holes. Push down first, then pull toward you to remove (Fig. 10) and (Fig. 11).
- Pull the valve body out toward you, feeding the hoses out as you pull (Fig. 12).
- Insert the new valve body, reversing the above steps to reinstall.
(Fig. 1) |
(Fig. 2) |
(Fig. 3) |
(Fig. 4) |
(Fig. 5) |
(Fig. 6) |
(Fig. 7) |
(Fig. 8) |
(Fig. 9)
|
(Fig. 10) |
(Fig. 11) |
(Fig. 12) |
Additional Resource:
Video: Handle Adjustment for Vinnata and Clairette Pull-Down Kitchen Sink Faucets
Click Here For Maintenance And Service Parts